Additional Repair and Replacement Instructions
332203F
37
13. Route end of the hose through the hose rollers (F
IG
.
81).
14. Install ball stop and dispensing valve (F
IG
. 82).
To install the ball stop:
a.
Position each half of the stop (45) near the out-
let end of the hose (F
IG
. 52).
b.
Thread screws (46) through holes in stop pieces
(45).
c.
Tighten nuts (47)until the outside edges of the
stop contact each other.
15. If hose reel was taken out of service, reinstall hose
reel. See XD40/XD50 Hose Reels Installation and
Operation instructions.
16. Remove cap from end of hose and install dispense
valve to hose end.
17. Remove c-clamp (A).
18. Pressurize hose reel and reverify spring tension.
Removing Spring Tension
1.
Relieve pressure, page 10.
2.
Pull the hose out far enough to engage the latch.
NOTE:
Listen for the loud click when the spool has
latched.
3.
Securely attach a c-clamp (A) to the reel spool as
shown in F
IG
. 83 to help prevent the reel from unin-
tentionally becoming unlatched and spinning freely.
F
IG
. 81
F
IG
. 82
45
46
47
Always wear heavy, non-slippery gloves when adjust-
ing the spring tension to protect your hands from being
cut on the hose reel.
F
IG
. 83
A