Hose Reel Reassembly
332203F
21
5. Install Bearings.
Medium Pressure Models Bearing Replacement:
NOTE:
Unless otherwise noted, Steps b - g refer to F
IG
.
32.
a.
Inspect seals, bearing balls, bearing nut and
bearing retainer for nicks and cuts. Replace
seals and any parts that are scratched or dam-
aged.
b.
If reusing bearing balls (35) clean bearing balls
with a soft, dry cloth.
c.
Grease bearing balls (35).
d.
Apply a thin layer of grease to seal (51). Install
seal around bearing retainer nut (42).
e.
Apply of thin layer of grease to the shaft o-ring
(50). Install o-ring around shaft (11).
f.
Apply a thin layer of grease to inside surfaces of
bearing retainer (5). Install balls (35) in retainer.
Distribute balls evenly and verify there are 24
and they are seated flat.
g.
Install bearing retainer (5) and bearing retainer
nut (42). Use a spanner wrench on the bearing
nut and tighten it securely. Torque to 20 ft. lbs
(27.12 N.m).
Low Pressure Ratchet and Bearing Models:
a.
Slide new bearing retainer assembly (49) onto
shaft. Refer to F
IG
. 33 for the correct orientation
of the bearing retainer for assembly.
6.
Install snap ring
(41)
over shaft on the inlet
side, using a snap ring pliers (F
IG
. 34). Do not
scratch the sealing surface (a).
F
IG
. 32
NOTICE
Use 3 to 3.5 cc of grease only. Over- greasing bear-
ing balls will cause the bearing to prematurely lock
up.
35
5
42
51
50
11
F
IG
. 33
F
IG
. 34
NOTICE
Be careful not to scratch or score the surface of the (a)
when using the snap ring pliers to remove the snap ring
(41). Damage to this surface could result in fluid leak-
age. Protect the surface by wrapping it with black elec-
tric tape.
49
41
a