Hose Reel Reassembly
26
332203F
f.
Reinstall outlet (30) to swivel (3). Replace and
tighten all bolts (37) securely. Torque bolts to 24
to 30 ft. pounds (32.54 to 40.67 N.m) (F
IG
. 51).
NOTE:
• Low Pressure Models (shown in F
IG
. 51) use 4
bolts (37).
• Medium Pressure Models (not shown) use 6
bolts (37).
• Always use all bolts provided.
14.Install ball stop.
To install the ball stop:
a.
Position each half of the stop (45) near the out-
let end of the hose (F
IG
. 52).
b.
Thread screws (46) through holes in stop pieces
(45).
c.
Tighten nuts (47)until the outside edges of the
stop contact each other.
15. Uncoil and extend the hose.
16. Remove c-clamp. Pull the hose firmly enough to
release the latch, then slowly allow the hose to
retract.
17. Remove cap from end of hose and install dispense
valve.
18. Pressurize hose and verify spring tension.
19. If necessary, adjust spring tension. See Spring Ten-
sion Adjustment instructions, page 35 and refer to
the Table 1: Spring Tension and Pre-turns (page 47)
to determine the number of spool rotations needed
to correctly set the spring tension for your reel
model and hose.
F
IG
. 51:
Low Pressure Model (shown)
F
IG
. 52
30
37
45
46
47
NOTICE
Always hold on to the hose while it is rewinding to avoid
damage to the reel.