Graco Reactor 2 Hydraulic, Операция

Страница: 46 / 70

Startup
11. Press to activate ADM.
12. If necessary, setup the ADM in Setup Mode. See
Advanced Display Module (ADM) Operation,
page 32 .
13. Preheat the system:
a. Press to turn on hose heat zone.
This equipment is used with heated luid
which can cause equipment surfaces
to become very hot. To avoid severe
burns:
• Do not touch hot luid or equipment.
• Do not turn on hose heat without luid
in hoses.
• Allow equipment to cool completely
before touching it.
• Wear gloves if luid temperature
exceeds 110°F (43°C).
Thermal expansion can cause
over-pressurization, resulting in
equipment rupture and serious injury,
including luid injection. Do not
pressurize system when preheating
hose.
b. If you need to circulate luid through the
system to preheat the drum supply, see
Circulation Through Reactor, page 47 .
If you need to circulate material through
the heat hose to the gun manifold, see
Circulation Through Gun Manifold, page 48 .
c. Wait for the hose to reach set point
temperature.
NOTE: NOTE:
NOTE: Hose heat-up time may increase at
voltages less than nominal 230 VAC when
maximum hose length is used.
d. Press to turn on A and B heat zones.
46 334945C