Graco Reactor 2 Hydraulic, Операция

Страница: 31 / 70

Setup
Lubrication Lubrication
Lubrication System
System
System Setup
Setup
Setup
Component Component Component AAA (ISO) (ISO) (ISO) Pump: Pump: Pump: Fill ISO lube reservoir
(LR) with Graco Throat Seal Liquid (TSL), part
206995 (supplied).
1. Lift the lubricant reservoir (LR) out of the bracket
(RB) and remove the container from the cap.
2. Fill with fresh lubricant. Thread the reservoir onto
the cap assembly and place it in the bracket (RB).
3. Push the larger diameter supply tube (ST)
approximately 1/3 of the way into the reservoir.
4. Push the smaller diameter return tube (RT) into
the reservoir until it reaches the bottom.
NOTE:
NOTE:
NOTE: The return (RT) must reach the bottom of
the reservoir to ensure that isocyanate crystals
will settle to the bottom and not be siphoned into
the supply tube (ST) and returned to the pump.
5. The lubrication is ready for operation. No priming
is required.
Install Install
Install Fluid
Fluid
Fluid Temperature
Temperature
Temperature Sensor
Sensor
Sensor
The Fluid Temperature Sensor (FTS) is supplied.
Install FTS between main hose and whip hose (see
Related Manuals, page 15 ).
Install Install
Install Heated
Heated
Heated Hose
Hose
Hose to
to
to Proportioner
Proportioner
Proportioner
1. Remove cover (CV).
2. Route heated hose wires (HW) through strain
relief (SR) and install wires into the open screw
terminals on the terminal block (TB). Torque to
35 in-lb (3.95 N•m).
3. Reinstall cover (CV).
334945C 31