Graco Reactor 2 Hydraulic, Операция

Страница: 58 / 70

Maintenance
Gun Gun
Gun Check
Check
Check Valve
Valve
Valve Screens
Screens
Screens
Clean gun check valve screens regularly. See gun
manual.
Dust Dust Dust Protection Protection Protection
Use clean, dry, oil-free compressed air to prevent
dust buildup on control modules, fans, and motor
(under shield).
Vent Vent
Vent Holes
Holes
Holes
Keep vent holes on bottom and back of electrical
enclosure and sides and back of transformer
enclosure open..
Flush Flush Flush Inlet Inlet Inlet Strainer Strainer Strainer Screen Screen Screen
The inlet strainers ilter out particles that can plug the
pump inlet check valves. Inspect the screens daily as
part of the startup routine, and clean as required.
Isocyanate can crystallize from moisture
contamination or from freezing. If the chemicals used
are clean and proper storage, transfer, and operating
procedures are followed, there should be minimal
contamination of the A-side screen.
Note
Clean the A-side screen only during
daily startup. This minimizes moisture
contamination by immediately lushing
out any isocyanate residue at the start of
dispensing operations.
1. Close the luid inlet valve at the pump inlet and
shut off the appropriate feed pump. This prevents
material from being pumped while cleaning the
screen.
2. Place a container under the strainer base to catch
drain off when removing the strainer plug (C).
3. Remove the screen (A) from the strainer
manifold. Thoroughly lush the screen with
compatible solvent and shake it dry. Inspect the
screen. No more than 25% of the mesh should
be restricted. If more than 25% of the mesh is
blocked, replace the screen. Inspect the gasket
(B) and replace as required.
4. Ensure the pipe plug (D) is screwed into the
strainer plug (C). Install the strainer plug with the
screen (A) and o-ring (B) in place and tighten. Do
not overtighten. Let the o-ring make the seal.
5. Open the luid inlet valve, ensure that there are
no leaks, and wipe the equipment clean. Proceed
with operation.
Figure 10
58 334945C