Graco Reactor 2 Hydraulic, Операция

Страница: 32 / 70

Advanced Display Module (ADM) Operation
Advanced Advanced
Advanced Display
Display
Display Module
Module
Module (ADM)
(ADM)
(ADM) Operation
Operation
Operation
When main power is turned on by turning the main
power switch (MP) to the ON position, the power up
screen will be displayed until communication and
initialization is complete.
Then the power key icon screen will display until the
ADM power on/off button
is pressed for the irst
time after system power-up.
To begin using the ADM, the machine must be
active. To verify the machine is active, verify that the
System Status Indicator Light is illuminated green,
see Advanced Display Module (ADM), page 22 . If the
System Status Indicator Light is not green, press the
ADM Power On/Off button
. The System Status
Indicator Light will illuminate yellow if the machine
is disabled.
Perform the following tasks to fully setup your system.
1. Set pressure values for the Pressure Imbalance
Alarm to activate. See System Screen 1, page 36 .
2. Enter, enable, or disable recipes. See
Recipes Screen, page 36 .
3. Set general system settings. See
Advanced Screen 1 General, page 35 .
4. Set units of measure. See
Advanced Screen 2 Units, page 35 .
5. Set USB settings. See
Advanced Screen 3 USB, page 35 .
6. Set target temperatures and pressure. See
Targets, page 39 .
7. Set component A and component B supply
levels. See Maintenance, page 40 .
32 334945C