![background image](http://html1.mh-extra.com/html/graco/24z660/24z660_instructions-manual_2251638045.webp)
Injectors
3A5082G
45
Adjusting Grease Output Volume
Grease injectors are used to provide precise lubrication to each grease point in the system. If an injector is not
producing the correct amount of lubricant for a specific location on the vehicle or if a replacement injector of correct
size is not available, output spacer washers (110) can be installed to adjust the injector’s output volume (F
page 44).
Use the Injector Identification and Usage Table to determine which size injector is appropriate for the grease location.
To change output volume:
1.
If the injector is installed in the manifold:
a.
Relieve pressure,
page 11.
b.
Remove the feed line. Use a 5/8” deep well
socket to remove injector (101) from manifold
(119/120) (F
For all injector adjustments:
2.
Place injector (101) in a vise with outlet end (tube
connector) facing up.
3.
Use a 5/8 inch wrench to loosen and separate the
injector body (102) from the valve assembly (114).
Be careful not to misplace or damage the spring
(112), retainer cap (103) and o-ring (117) (F
page 44).
Injector Identification and Usage
Part No.
Injector
Size
Number of
Washers
Output
(in.
3
)
Recommendations for
Specific Lubrication Points
24Z682
0
0
0.002
Brake Shafts, transmissions, cross shafts, “S” cams
24Z683
1
1
0.005
Slack adjusters, 5th wheel pivot, and miscellaneous
points
24Z684
2
2
0.009
Drag link, tie rod ends, power steering linkage
24Z685
3
3
0.012
King pins, spring pins, spring shackles
24Z686
4
4
0.015
Miscellaneous points
24Z681
8*
4 0.026
5th Wheel plate
*Size 8 high output injectors cannot be changed.
F
IG
. 38
fluid line
101
119/120
F
IG
. 39
101
outlet
110
Содержание 24Z660
Страница 7: ...Typical System Installation 3A5082G 7 FIG 4 ...
Страница 11: ...Pump 3A5082G 11 Pump Dimensions FIG 7 ...
Страница 13: ...Pump 3A5082G 13 Mounting Bracket and Pump Dimensions FIG 9 ...
Страница 67: ...Notes 3A5082G 67 Notes ...