![background image](http://html1.mh-extra.com/html/graco/24z660/24z660_instructions-manual_2251638021.webp)
Pump
3A5082G
21
Quick Setup Guide - DMS and
Illuminated Remote Run Models
Pump Software
When the pump is powered,
“d7” displays for a short
period of time. If it does not
display, contact Graco
Customer Service.
By default, units with controllers are set to
operate in a timed mode with 7 minutes of
ON time and 2:53 hours of OFF time. The
unit should be powered up in OFF mode,
counting down from the 2:53 hours. If the unit powers up
in ON mode and has not been primed, hold the reset
button located on the control panel (example shown on
the right) for 1 second to move to the OFF mode.
NOTE:
•
A blinking number on the display indicates the pump
is in SETUP MODE.
•
In RUN MODE numbers on the display do not blink.
•
After 60 seconds of no activity, the device returns to
RUN MODE in the OFF Time cycle and the OFF
Time restarts counting down the total programmed
amount of time. It does
not
resume the countdown
from the point where the cycle was interrupted when
you entered SETUP MODE.
Entering Setup Mode
Press both the UP and DOWN
ARROW buttons together for 3
seconds to enter the SETUP
MODE.
NOTE:
If the lock LED is
lit after entering Setup
Mode and four 0000’s
are displayed, the unit
has a PIN Code lock out
enabled. See the
following section:
Entering a PIN Code to
Access Setup Mode.
Entering a PIN Code to Access Setup Mode
The controller does not require a user to provide a PIN
code to access the programming features of the unit.
However, Graco understands that some users may want
to protect the programming settings and therefore, an
option for adding PIN Code authorization is available.
The instructions for setting up PIN Code Authorization
are provided in the Advanced Programming section of
this manual. See page 32.
To enter the PIN Code:
1.
Press both the UP and
DOWN ARROW buttons for 3
seconds.
2.
The LED next to the LOCK ICON on
the display lights and the 4 zeros
appear on the display indicating the
system requires a PIN Code entry to run the in
SETUP MODE.
3.
The cursor is automatically
positioned to enter the first
character of the PIN Code.
Use the UP and DOWN
ARROW buttons to move up
and down through the numbers 0-9 until the first
number in the PIN code is displayed in the field.
4.
Press the ENTER button to set the
number. The cursor automatically
moves to the next number field.
5.
Repeat steps 3 and 4 for each PIN Code prompt
field.
F
IG
. 27
Содержание 24Z660
Страница 7: ...Typical System Installation 3A5082G 7 FIG 4 ...
Страница 11: ...Pump 3A5082G 11 Pump Dimensions FIG 7 ...
Страница 13: ...Pump 3A5082G 13 Mounting Bracket and Pump Dimensions FIG 9 ...
Страница 67: ...Notes 3A5082G 67 Notes ...