![background image](http://html1.mh-extra.com/html/graco/24z660/24z660_instructions-manual_2251638025.webp)
Pump
3A5082G
25
3.
Use the UP or DOWN
ARROW button to scroll
through numerals 0 to 9 until
the desired number appears
in the second HH number
field.
4.
Press the ENTER button to lock in the
selection.
The next number field to the right
flashes and the LED lights under MM; indicating it is
ready to program the minutes fields.
5.
Repeat steps 1 - 4 to set the next MM (minutes)
fields.
6.
After pressing the ENTER button to set
the last MM field, the OFF Time
information is saved and the pump
automatically switches to the RUN
MODE.
DMS
™
Models
Downloading Data
1.
Remove the USB cover from the USB port.
2.
Plug a USB flash drive into the USB port.
NOTE:
The pump stops pumping as soon as the USB
flash drive is plugged into it.
3.
The system automatically begins downloading data
to the USB drive.
4.
“data” is displayed while the system
is downloading files.
5.
When download is finished, “done” is
displayed.
6.
The pump restarts cycle in the OFF mode.
7.
Remove the USB flash drive. Replace the USB
cover and hand tighten the cover securely over USB
port.
Storing Pump Program Settings to the
Flash Drive
The pump program settings file is named:
GRACO/Config/config.bin. This file cannot be modified.
Modification of the file or file name may cause it to be
unusable.
1.
Plug the USB flash drive into the USB port.
NOTE:
The pump stops pumping as soon as the USB
flash drive is plugged into it.
2.
The system automatically begins downloading data
to the USB drive.
3.
“data” is displayed while the system
is downloading files.
4.
When download is finished, “done” is
displayed.
5.
The pump restarts cycle in the OFF mode.
6.
After the download is
complete, press and hold the
UP and DOWN ARROW
button for 3 seconds to store
the current setup to the USB
flash drive.
7.
“data” is displayed while the unit is
downloading and storing the
configuration on the USB drive.
8.
When configuration is stored, “done”
is displayed.
9.
The pump restarts cycle in the OFF mode.
10. Remove the USB flash drive.
Uploading Pump Program Settings to the
Pump
1.
Plug the USB flash drive into the USB port.
NOTE:
The USB flash drive must contain file
GRACO/Config/config.bin.
The pump stops pumping as soon as the USB flash
drive is plugged into it.
Содержание 24Z660
Страница 7: ...Typical System Installation 3A5082G 7 FIG 4 ...
Страница 11: ...Pump 3A5082G 11 Pump Dimensions FIG 7 ...
Страница 13: ...Pump 3A5082G 13 Mounting Bracket and Pump Dimensions FIG 9 ...
Страница 67: ...Notes 3A5082G 67 Notes ...