Graco 24Z660, Инструкция по эксплуатации

Страница: 20 / 68

Pump
20 3A5082G
Programming the Pump
Control Panel Overview (F
IG
. 26)
NOTE: Programming instructions begin on page 21.
F
IG
. 26
DISPLAY
•
A blinking LED under HH, MM, SS
or ## identifies type of measurement
unit you are setting; i.e., HH is
hours.
•
A blinking number on the display
indicates the pump is in SETUP
MODE.
•
In RUN MODE displayed numbers
count up or down. See Time ON and
Time OFF.
ON TIME
•
LED lights when ON Time is
running.
•
Display shows time as MM:SS
(minutes and seconds).
i.e., 08:30 is 8 minutes: 30
seconds.
•
Counts down from a set time to
zero.
OFF TIME
•
LED lights when OFF Time is
used to control Pump OFF
function.
•
Value is entered in HH:MM.
•
Displays in HH:MM (hours and
minutes) when > 1 hour.
•
Times pump rest between cycles.
•
Counts down from set time to
zero.
ALARM ICONS
LED next to icon lights when a
fault / warning event occurs
during a run cycle. See page 36
for a complete description of
these alarm scenarios.
PIN ICON
•
LED next to icon lights
indicating PIN is required
to enter setup.
•
In SETUP MODE LED
lights when setting up the
PIN.
COLD DELAY
LED next to icon lights
indicating when Cold Delay
function is enabled.
LEFT DIRECTION ARROW /
RESET
•
In SETUP MODES, moves
cursor in display one field to the
left.
•
In RUN MODE: single press
clears warning.
•
In RUN MODE: Pressing for 1
second ends run cycle if there
are no warnings.
•
In ALARM MODE: pressing and
holding for 3 seconds clears
fault / warning and switches
cycle to OFF MODE.
RIGHT DIRECTION ARROW /
MANUAL RUN / ENTER
•
In SETUP MODE, saves
entry, moves cursor in display
one field to the right or to the
next setup step.
•
In RUN MODE starts a
manual run cycle.
UP and DOWN ARROW
•
Hold both the UP and DOWN ARROW
buttons down together for 3 seconds to enter
SETUP MODE.
•
In SETUP MODE, increases or decreases
number values shown in display.