GORMAN-RUPP VG3B3-B, Инструкция по установке, эксплуатации и обслуживанию

Страница: 193 / 1180

Adhesive Dispensing Gun
Part
# 2614083
Simpson EDT22B
2013-12-19 2614083 Adhesive Dispensing Gun.doc 1 of 1
The Simpson EDT22B dispenser
will provide fast, trouble free
injections with a minimum of
effort. AASI is supplying one (1)
EDT22B as a special tool for the
installation of all size adhesive
anchors. It is designed for use with
Simpson 22 oz cartridges.
It is important that the Installing
Contractor review and read the
complete operating instructions
provided for the dispensing gun
before using this product.
The adhesive dispensed with the first two (2) trigger pulls is not suitable for making fastenings
and must be discarded. Likewise, after changing a static mixing nozzle, the initial flow must be
discarded. The mixed adhesive is injected directly into the hole drilled in the solid concrete base
material.
General Instructions for use:
1. Retract pistons – push trigger forward and pull on retracting handle at the rear of the tool.
2. After preparing cartridge, insert cartridge into carriage. Make sure cartridge is aligned
with pistons and sits level in carriage.
3. Dispense adhesive by squeezing trigger. Operation: Squeeze trigger. Hold for 2-3
seconds, release and repeat. Tool can be damaged by applying too much pressure! This
can also cause cartridge to deform resulting in adhesive blowing past wipers.
4. To release pressure, push trigger forward. This will stop the flow of adhesive.
5. Should it be necessary, the drive mechanism can be recalibrated by turning the adjusting
screw at the rear of the tool body (see below).
Cleaning and Maintenance:
It is very important to keep the center piston rod clean and to oil them frequently to ensure better
function. Clean dispensing tool after use. Wipe drive and plunger rods with oil to prevent rust.
Clean adhesive paste from tool using a cloth and appropriate solvent.
Recalibration:
1. Turn the adjusting screw clockwise the whole way down, the piston rod can now be
moved back and forth.
2. Turn the adjusting screw counter-clockwise until the piston rod can be moved by
squeezing the trigger.
GENERAL SAFETY
Wear gloves and eye protection when using the dispenser.