GORMAN-RUPP VG3B3-B, Инструкция по установке, эксплуатации и обслуживанию

Страница: 1048 / 1180

5.6.3 Disassembly
Prior to disassembling, ensure the power supplies are disconnected and there
are no moving parts.
The bearing sleeve is of the spherically seated, self-aligning type. The opposite drive end
bearing is normally insulated for larger motors (or when specified). On some motors, the
insulation is bonded to the spherical seat of the bearing housing.
ATTENTION!
Extreme care must be exercised in removing the bearing sleeve from the insulated support
to avoid damaging this insulation.
The following is the recommended procedure for removing the bearing sleeve:
(a) Remove the oil drain plug in the housing bottom and drain the oil sump.
(b) Remove all instrumentation sensors that are in contact with the bearing sleeve. These
would include resistance temperature detectors, thermocouples, thermometers, etc..
(c) Remove the socket head bolts holding the bearing cap and the inner air seal. The end
cover plate must also be removed if the non-drive end bearing is being disassembled.
Remove the bearing cap and top half of the inner air seal. Place them on a clean, dry
surface to avoid damage to the parting surfaces.
(d) Remove the top half of the bearing sleeve using suitable eyebolts in the tapped holes
provided. Lift the bearing top straight up and avoid any contact with the shoulders of the
shaft journals that might damage the thrust faces of the bearing. Place on a clean, dry
surface taking care to prevent damage to either the parting surfaces or the locating pins
that are captive n the top bearing half.
(e) Remove the screws at the partings in the oil ring and dismantle the ring by gently tapping
the dowel pin ends with a soft face mallet. Remove the ring halves and immediately
reassemble them to avoid any mix up I parts or damage to the surfaces at the partings.
(f) Pull up on the garter spring surrounding the floating labyrinth seal and carefully slip out the
top half. Rotate the garter spring until the lock is visible. Twist counter-clockwise to
disengage the lock, remove the garter spring then rotate the lower half of the seal out of
the groove in the bearing housing. Note the condition of these floating labyrinth seals. If
they are cracked or chipped, they must be replaced. Do not attempt to reuse a damaged
seal.
(g) To remove the bottom bearing half, the shaft must be raised a slight amount to relieve
pressure on the bearing. On the drive end, this can be done by jacking or lifting on the
shaft extension. Protect the shaft. On the non-drive, jacing or lifting can be done using
bolts threaded into the tapped holes provided in the shaft end.
25