25
Field
Description
Authentication Method
You can choose
AUTO
,
CHAP
, or
PAP
.
Connection Type
You can choose
Continuous
,
Connect on
Demand
, or
Manual
.
Idle Time (s)
If choose
Connect on Demand
, you need to
enter the idle timeout time. Within the preset
minutes, if the router does not detect the flow of
the user continuously, the router automatically
disconnects the PPPoE connection.
Bridge
You can select
Bridged Ethernet
,
Bridged
PPPoE
, or
Disable Bridge
.
AC-Name
The accessed equipment type.
Service-Name
The service name.
802.1q
You can select
Disable
or
Enable
. After enable
it, you need to enter the VLAN ID. The value
ranges from 1 to 4095.
Apply Changes
Click it to save the settings of this page
temporarily.
Return
Click it to return to the
Channel Configuration
page.
Reset
Click it to refresh this page.
Source Mac address
The MAC address you want to clone.
MAC Clone
Click it to enable the MAC Clone function with
the MAC address that is configured.
ATM Setting
Click
ATM Setting
in the left pane, the page shown in the following figure appears. In this page, you can configure the
parameters of the ATM, including QoS, PCR, CDVT, SCR and MBS.
The following table describes the parameters of this page:
Field
Description
VPI
The virtual path identifier of the ATM PVC.
VCI
The virtual channel identifier of the ATM PVC.
QoS
The QoS category of the PVC. You can choose
UBR
,
CBR
,
rt-VBR
, or
nrt-VBR
.
PCR
Peak cell rate (PCR) is the maximum rate at
which cells can be transmitted along a connection
in the ATM network. Its value ranges from 1 to
65535.
CDVT
Cell delay variation tolerance (CDVT) is the
amount of delay permitted between ATM cells (in
microseconds). Its value ranges from 0 to
4294967295.
SCR
Subtain cell rate (SCR) is the maximum rate that
traffic can pass over a PVC without the risk of cell
loss. Its value ranges from 0 to 65535.
MBS
Maximum burst size (MBS) is the maximum
number of cells that can be transmitted at the
PCR. Its value ranges from 0 to 65535.
Содержание MSW300Np4
Страница 22: ...21 In the DHCP Mode field choose None The page shown in the following figure appears...
Страница 45: ...44...