Global411 MSW300Np4, Руководство пользователя

Страница: 11 / 52

10
Wizard
When subscribing to a broadband service, you should be aware of the method by which you are connected to the Internet.
Your physical WAN device can be either PPP, ADSL, or both. The technical information about the properties of your Internet
connection is provided by your Internet Service Provider (ISP). For example, your ISP should inform you whether you are
connected to the Internet using a static or dynamic IP address, and the protocol that you use to communicate on the Internet.
The Wizard page guides fast and accurate configuration of the Internet connection and other important parameters. The
following sections describe these various configuration parameters. Whether you configure these parameters or use the
default ones, click NEXT to enable your Internet connection.
In the navigation bar, choose Wizard . The page shown in the following figure appears.
The following table describes the parameters in this page:
Field Description
VPI
Virtual path identifier (VPI) is the virtual path between two
points in an ATM network. Its valid value is in the range of
0 to 255. Enter the correct VPI provided by your ISP. By
default, VPI is set to 0 .
VCI
Virtual channel identifier (VCI) is the virtual channel
between two points in an ATM network. Its valid value is in
the range of 32 to 65535. (0 to 31 is reserved for local
management of ATM traffic) Enter the correct VCI provided
by your ISP. By default, VCI is set to 35 .
After setting, click Next , the page as shown in the following figure appears.
There are five WAN connection types: PPP over ATM (PPPoA) , PPP over Ethernet (PPPoE) , 1483 MER , 1483 Routed and
1483 Bridged . The following describes them respectively.
PPPoE/PPPoA
In the Connection Type page, set the WAN connection type to PPP over Ethernet (PPPoE) , the encapsulation mode to
LLC/SNAP .