Global411 MSW300Np4, Руководство пользователя

Страница: 24 / 52

23
WAN
Choose Network > WAN . The WAN page that is displayed contains WAN , ATM Setting and ADSL Setting .
WAN
Click WAN in the left pane, the page shown in the following figure appears.
In this page, you can configure WAN interface of your router.
The following table describes the parameters of this page:
Field Description
Default Route Selection You can select Auto or Specified .
VPI
The virtual path between two points in an
ATM network, ranging from 0 to 255.
VCI
The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to
31 are reserved for known protocols)
Encapsulation You can choose LLC and VC-Mux .
Channel Mode
You can choose 1483 Bridged , 1483 MER ,
PPPoE , PPPoA , 1483 Routed or IPoA .
Enable NAPT
Select it to enable Network Address Port
Translation (NAPT) function. If you do not
select it and you want to access the Internet
normally, you must add a route on the uplink
equipment. Otherwise, the access to the
Internet fails. Normally, it is enabled.
Enabel IGMP
You can enable or disable Internet Group
Management Protocol (IGMP) function.
PPP Settings
User Name
Enter the correct user name for PPP dial-up,
which is provided by your ISP.
Password
Enter the correct password for PPP dial-up,
which is provided by your ISP.
Type
You can choose Continuous , Connect on
Demand , or Manual .
Idle Time (min)
If set the type to Connect on Demand , you
need to enter the idle timeout time. Within the
preset minutes, if the router does not detect
the flow of the user continuously, the router
automatically disconnects the PPPoE
connection.
WAN IP Settings
Type
You can choose Fixed IP or DHCP .

If select Fixed IP , you should enter the
local IP address, remote IP address and
subnet mask.

If select DHCP , the router is a DHCP
client, the WAN IP address is assigned