GILES GBF Series, Руководство по эксплуатации и обслуживанию

Страница: 44 / 130

32
Pre-Operation
GBF Ventless Electric Fryer
GBF-35D & 50D-VH
The Heating Elements quickly become extremely hot when energized! Skin contact may result
in severe burn injury.
1. Follow steps previously described in Section 4.01 .
2. Liberally dampen a sponge, or towel, with water
and wipe down Heating Elements ① leaving them
visibly moist.
3. Set the Power Switch ② to the [ON] position.
4. Wait for the Controller to power up. Alarm sounds
and the message “ POWER FAILURE PRESS [START]
TO PREHEAT” is displayed on the Upper Display
and “ HOLD” on the Lower Display ③.
5. Press the [START] key ④ ... a setpoint of 335
°F
should display
, the alarm will silence and the
Controller wil enter PREHEAT .
6. Set the Selector Switch ⑤ to the [COOK] position.
The HEAT light ⑥ should turn ON . Leave switch in
the [COOK] position NO MORE THAN 10 to 12
SECONDS .
7. Return Selector Switch ⑤ to the [OFF] position
NOTE: If during this test, should the HEAT light
turn OFF , an alarm sound and the Upper Display
show a “ MAX ELEMENT TEMP” error message,
return Power Switch to the [OFF] position and
proceed on to the next step, as this event is also an
indication that the test was successful.
The following test will confirm that Heating Elements are being powered and properly energized.
1
2
3
4 5
6
4.03 Heating Element Test
4.03.1 Heating Element Test, Computer Controller
Continued on Next Page