GiBiDi AGO 400, Инструкция по установке

Страница: 14 / 44

14 AGO 15 AGO
UK UK
For the manual door locking and unlocking act with the supplied key on the screw C (See PIC. 1).
1 - Remove the protection cap
2 - Insert the key into the seat allocation as in FIG.1 and turn the key in the sense of the arrow to the top of the
gearmotor to unlock and in the opposite block.
EMERGENCY MANOEUVRE
INSTALLATION
A
PIC. 1
PIC. 2
B
C
D
Pillar bracket
Gate bracket
Release
Piston rod
A
C
D
B
ANTICLOCKWISE:
RELEASED
CLOCKWISE:
BLOCKED
5 - Install the gear motor on to the support plate A and fix it with the bolt.
6 - With gate's leaf closed, turn and slide the screw of gear motor's D shaft, until the end of the stroke.
7 - Screw D shaft back on 1 complete turn of 360º (PIC. 5).
PIC. 4
PIC. 5
X
Y
6
.0
W
Z
1°
360°
To operate a good installation of the gear motors AGO, follow these instructions:
1 - Open the box and take out gear motor. Make sure that it has not been damaged during the transport.
2 - Make sure that the leaf of the gate is perfectly horizontal.
3 - Place the gear motor tilted approximately 1º below the horizontal line (PIC. 3) .
PIC. 3
4 - Fix the support plate A on the pillar beside the leaf, taking in account the measures shown in TAB. 1 and PIC. 4.
Do not forget inclination.