GiBiDi AGO 400, Инструкция по установке

Страница: 11 / 44

10 AGO 11 AGO
UK
Our compliments for your excellent choice. AGO electro-mechanical gear motor has been produced for reliability
and high quality.
This Manual will offer information you may need to install your gear motor assuring long-lasting performance
and to safeguard your safety.
HOWEVER, CAUTION IS UNQUESTIONABLY INDISPENSABLE
AND NOTHING IS BETTER THAN PREVENTING ACCIDENTS.
Gi.Bi.Di. Srl products have been made to conform with rules and laws in force at time of manufacture.
INTRODUCTION
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important for the safety of persons to follow these instructions.
Keep this instruction manual.
This manual is designed exclusively for the specialized installation expert in the criteria of construction
and equipment to assist in the protection against accidents in the installation and use of the gate; door and
automation of such gates (adhere to the rules and laws in force).
On completion, the installer should issue to the end consumer an instruction manual according to EN 12635.
Before proceeding with the installation, the installer must provide an analysis of the identification and
management of risks as per the standards EN 12453 and EN 12445).
All wiring of the various external electrical components connected to the automation (e.g. Photocells, flashing
lights, keypads etc.) must be carried out according to EN 60204-1 and the amendments made of the point
5.2.2 of EN 12453.
It is prohibited to do any repair or adjustment of the equipment if you have not taken all necessary precautions
to avoid possible accidents (example: power supply disconnected, engine block).
All mechanisms in motion must be equipped with appropriate protections.
The mains power line must be protected for maximum current in locked rotor condition.
Install the gear motor on gates that conform to EN 12604.
Perform the measure of strength developed by the gear motor and adopt the measures as per EN 12445.
Positioning photocells: These safety devices must be installed at a height not exceeding 70cm from the
ground and at a distance from the floor movement of the door of no more than 20cm.
Their proper functioning of the photocells must be verified at the end of installation according to Section
7.2.1 of EN12445.
Qualified people must carry out all repairs.
Keep the activation controls of automation out of reach of children. The controls should be installed at a
minimum 1.5m height above the ground and outside the range of actions of moving parts such as the gate.
INSTALLATION WARNINGS
UK
Operate the remote only in view of automation. All activation actions must be executed only at points from
where the automation is fully visible.
Any unauthorized and arbitrary modification made to this product releases the company Gi.Bi.Di. Srl from any
liability resulting from damage or injury to things, people or animals.
The non-observance of regulations and of safety standards here listed releases the company Gi.Bi.Di. Srl
from any liability resulting from damage or injury to things, people or animals.
Store carefully this manual in a suitable place known to all interested people.
The automation must be coupled to a control board equipped with torque regulation that provides an
anti crushing safety as described in EN 12453 - EN 12445.
During the installation and the use of the automation, pay attention to the following safety rules:
Distance security!
Mechanisms moving!
Do not install automation in an environment saturated with explosive mixtures!
Electric Shock!
Use gloves!
Use welding glasses!
Maintain ear protection!
SAFETY RULES
Before each intervention remove power through the switch and lock in that position.
The equipment must be maintained so as to preserve the conditions that ensure safe and efficient
operation.
Always use original spare parts.
Do not make interventions that modify the machine.
The modified equipment requires new CE mark.
The settings of the operator must be performed by qualified personnel, in accordance with the rules of
reference. During these operations, provide the presence of two operators for safety.
MAINTENANCE