GEOSATpro DSR200c, Руководство пользователя и инструкция по установке

Страница: 45 / 61

www.geosatpro.com Toll Free 888-483-4673
43
The easiest method to aim the satellite dish is to temporarily place
the satellite receiver connected to a small television near the satellite
dish. This method allows the installer to see the signal changes that
occur with small dish movements. It is extremely difficult to install
the satellite system if the TV is inside the home and out of the view of
the installer. Attempting to communicate the signal readings with a
second person viewing the TV can complicate the aiming process!
CAUTION: DO NOT ATTEMPT TO OPERATE
ELECTRONIC DEVICES IN AN UNSAFE
LOCATION OR IN VIOLATION OF SAFEGUARDS
PROVIDED IN THIS MANUAL OR ANY OTHER
EQUIPMENT MANUAL PROVIDED WITH THIS
GLORYSTAR SATELLITE SYSTEM.
Remove the satellite receiver and remote control from the packaging.
Inspect the unit before operation. If any equipment is damaged or
if you have any questions, please immediately contact Glorystar or
your reseller.
Install the two included AAA batteries into the remote control battery
compartment..
Plug the satellite receiver’s AC power plug into the same power
strip. Power ON the Master Power Switch on back of the receiver.
The receiver will power on and the front panel will display “ boot ”.
The television will display the Language Selection Screen.
Connect the satellite receiver to the TV.
The most basic connection is to locate the
included 6’ coax jumper with the plastic
moulded ends and connect from the TV
/VCR port on the satellite receiver to the
Antenna connection on the TV. Plug the
television power plug into a surge protected
AC power strip. Turn the TV power ON
and set the TV to channel 3. The TV is now
ready to view the satellite receiver.
Connect Receiver to a TV