GEOSATpro DSR200c, Руководство пользователя и инструкция по установке

Страница: 59 / 61

www.geosatpro.com Toll Free 888-483-4673
57
Satellite receiver displays “No Signal” only during very hot or cold weather.
An aging or defective LNBF can drift off frequency and cause the loss of reception
during the heat of the day or coolness of the night. Replace the LNBF.
Satellite receiver displays “No Signal” or the picture breaks up during high
winds. Strong winds can move the dish out of alignment and cause the signal to be
reduced or lost. Make sure the mast support legs have been installed and the mast
is secure and not moving. Once the mast is stable, follow the aiming instructions
to re aim the dish and tighten all hardware to prevent any movement.
Are more channels available on Galaxy 19?
Many more free channels are
available for viewing on this and other satellites. This receiver is capable of
receiving the additional free TV and Radio channels on Galaxy 19. Glorystar
will only provide the warranty free technical support for the reception of the
Glorystar programming in the Glorystar mode. The Automatic channel updating
feature (OTA) must be turned off to prevent the weekly OTA automatic updates
from erasing the additional channels (see the OTA Updating section on page 25).
The customer will be responsible for manually updating the receiver with any new
channels or firmware upgrades.
Scanning the Satellite for Additional Channels (optional)
Press MENU on the remote control.
Press VOLUME RIGHT arrow to enter the Installations Menu.
Highlight Channel Search and press OK
Enter Password 0,0,0,0
Highlight Satellite and select Galaxy 19-KU
Highlight Search Options and change setting to Blind Scan
Highlight Search and press OK
Highlight Search Options and select FTA
Highlight Search and press OK to begin satellite scan. This process will
take approximately 10 minutes
After the Scanning is complete, select YES to save the found channels
Press EXIT on the remote to begin viewing channels.
Do not call to activate programming or subscription. All scanned channels are
free to air and available with no monthly charge. The receiver assigns channel
numbers while scanning; therefore, no uniform channel line-up will be available
after a scan is performed.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Picture is skipping and/or audio jumps during DVR functions. A USB device
may not have enough transfer speed to handle the DVR function. Make sure that
the USB device is 2.0 type. Try another USB drive with better processing speed.
Thumb drives often cannot process the data and the picture pixilates or freezes.
Message window displays “NTFS: Not supported” or “Not Hi-Speed” when
trying to record. The connected USB device is not formatted to FAT32 type. Use
the receiver USB format function to format to FAT32 type
.
FAQ - DVR1100c