GEOSATpro DSR200c, Руководство пользователя и инструкция по установке

Страница: 49 / 61

www.geosatpro.com Toll Free 888-483-4673
47
The Orange Signal Button on the top of the remote toggles the Signal
Meter ON/OFF. The Blue Button on the remote toggles the meter
beeping sound ON/OFF.
Aim the dish towards the distant landmark which corresponds with
the compass reading for the satellite. Observe the Signal Quality (
Q
)
reading on Channel 901, RT News Channel and very slowly pan
the dish.
If the dish is panned beyond 15 degrees from the satellite compass
reading and no Signal Quality (
Q
) is detected or television
programming displayed, return the dish to the starting position then
slowly sweep 15 degrees in the opposite direction.
Locate and Peak Satellite Signal
When the correct satellite is found
the beeping sound changes to a
higher tone and the Signal Quality
(
Q
) bar turns Green. The meter will
display an increased Signal Quality
( Q ) reading. RT News Channel
programming will be visible.
If no Green Signal Quality
(Q)
reading is detected, increase or
decrease the elevation by one degree increments and repeat the
slow sweep. The elevation may need to be ad/- 5 degrees
depending on the post being plumb. Move the dish very slowly to
allow the receiver to process the signal information. A movement of
just 1/16th of a inch can result in a perfect or no signal. This process
may need to be repeated many times to aim and peak the quality of
the signal.
When the dish is correctly aimed,
the
RT News Channel
television
programming will be displayed and
the Signal Quality ( Q ) reading will
read 50% or higher. A stable level on
the 6 second bar graph indicates good
LNBF and dish alignment.