GEOSATpro DSR200c, Руководство пользователя и инструкция по установке

Страница: 43 / 61

www.geosatpro.com Toll Free 888-483-4673
41
Semi-tighten the elevation fastening nuts to hold the dish in position.
Do not tighten the fasteners for final setting at this time. Additional
adjustment will be needed to locate and peak the satellite signal.
When setting the elevation
angle on an offset dish, it is
Do not grip the edges of the reflector to adjust the dish. Always
hold the dish by the elevation bracket during elevation or azimuth
(side-to-side) adjustments. Applying pressure to the edges of the
reflector will affect the accuracy of the satellite signal reflection
from the dish into the LNBF.
In North America, satellites are always located South of your location.
To correctly aim the dish you must first accurately determine the
exact compass reading angle (azimuth). Metals, electricity and other
magnetic disturbances can cause the compass to point incorrectly.
Compass readings should be made at least 10 feet in front of or
behind the metal satellite dish and away from any large metal object
such as metal buildings, air conditioners, vehicles, utility and power
lines or electrical panels. Check compass reading several times to
reduce install time and the need to hunt the entire southern sky for
the satellite signal.
Compass Reading: Azimuth
important to note that the dish will
appear be aimed lower than the
actual elevation angle to the satellite.
The scale on the elevation bracket is
calibrated for accurate aiming when
the post is installed perfectly plumb
(leveled on all sides). The dish elevation
angle cannot be found using the angle
finder on the LNBF arm or on the face
of the dish.