GEOSATpro DSR200c, Руководство пользователя и инструкция по установке

Страница: 41 / 61

www.geosatpro.com Toll Free 888-483-4673
39
The Most Critical step to providing a
stable mounting platform for the dish is the
installation of the Tripod Support Legs. If
the lag bolts cannot be secured directly into
a stud or rafter, the legs should be secured
into plywood sheeting with either a backing
a toggle bolt or to a 2 x 4” that is lag bolted
between the rafters or studs.
The legs are required to support the wind load on the universal post
mount. Failure to install the tripod support legs will result in collapse
of the post even during moderate winds. The post is not designed to
solely support the dish without the tripod support legs. If you hire a
local installer, be sure that the tripod support legs are installed.
Place the assembled dish onto the top of the post with the Structural
Bolt #6 sitting on top of the post. Loosely secure the mast clamp
hardware until the dish only moves when applying light pressure to
the rotate the reflector.
Not Level Level
LNBF Clamp Assembly
Assemble the single LNBF Clamp
and attach to the LNBF arm.
Install the LNBF into the clamp with
the white cap facing the dish.
Center the bubble in the level then tighten
the 4 flange bolts to secure the post. It is
very important to make sure that the post is
perfectly plumb (level on all sides).