General Monitors FL3101H, Руководство пользователя

Страница: 12 / 72

Models FL3100H/3101H
5
Apply Power to the Detector
Two light emitting diodes (LED’s) are visible through the UV window (the larger window on
UV/IR units). Immediately upon powering up the detector, both LED’s will start blinking
alternately for 10 seconds. The unit will then enter the “Ready” mode. During the “Ready"
mode, the green LED will flash off 1 second, every 10 seconds.
Test the Detector Using the TL100 (UV only) or TL105 (UV/IR)
Test the integrity of your system by using either the TL100 UV test lamp (part# TL100-2) for the
FL3101H or the TL105 UV/IR test lamp for the FL3100H (part# TL105-0-2).
The original
configuration (i.e. sensitivity and relay options) can be changed by using the “Switch Selectable
Options” (Table 11) and then changing the dipswitch settings located on the bottom of the
power board (SW1).
The instrument is now ready to operate. Please consult the manual for more information on the
instrument’s many features.
NOTE : If you have any problems in the set-up or testing of the detector, please refer to the
“Troubleshooting Section”, or call the factory direct.
Worldwide service is available by calling:
Lake Forest, California
(24 hr. service) Toll Free: +1-800-446-4872
Phone: +1-949-581-4464
Fax: +1-949-581-1151
Houston, Texas Phone: +1-281-855-6000
Fax: +1-281-855-3290
Ireland Phone: +353-91-751175
Fax: +353-91-751317
Singapore Phone: +65-6748-3488
Fax: +65-6748-1911
United Arab Emirates Phone: +971-4-8815751
Fax: +971-8-4480051
United Kingdom Phone: +44-1625-619583
Fax: +44-1625-619098