General DataCommc SpectraComm ES, Инструкции по установке и эксплуатации

Страница: 54 / 62

Application Guidelines General Application Information
A-2 SpectraComm Ethernet Switch 076R204-000
Installation and Operation Manual Issue 2
SC-ES Default Configurations
SC-ES is shipped from the factory with the ordered Default Profile that most suits the customer
application. The Profile establishes default values for most configurable settings required by the
SC-ES.
Table A-1 describes Default Configuration Profile #1. Your factory defaults may vary,
depending on which profile was ordered with your unit.
Users can change values from the default setting via Supv or Admin access to the CLI or the web
interface. The Default Profile can be reloaded back into a SC-ES whenever a “clean baseline” is
desirable prior to downloading a batch file configuration. To accomplish this, type
default all
at the command prompt, or add the
# default all
command uncommented at the start of
your configuration batch file. You may need to reboot the unit.
Table A-1 Default Configuration
Setting Default
System Prompt ES-09 or ES-18
Inactivity Timer 900 seconds
HTTP Service Disabled
SNMP Service Disabled
Mgt Configuration Disabled
Port 1 through Port n Enabled
Auto-negotiate Enabled
Speed 10 Mbps
Mode Half Duplex
FDX Flow Control On
MDIX Not Forced
Auto-MDIX Auto
Port Mirroring Disabled
Auto-Stats (Future Use)
Virtual LAN
(Future Use)
SNMP Configuration
Community public ro en
Name “YOUR SYSTEM NAME”
Contact “YOUR SYSTEM CONTACT”
Location “YOUR SYSTEM LOCATION”
User Accounts Configuration admin
supervisor
gdc
Console (craft port) Authentication
Disabled
Auto Reboot Disabled
To enable, uncomment the batch file
line:
# reboot