General DataCommc SpectraComm ES, Инструкции по установке и эксплуатации

Страница: 19 / 62

076R204-000 SpectraComm Ethernet Switch 2-1
Issue 2 Installation and Operation Manual
Chapter 2:
Installation & Connections
Overview
This chapter describes installation and setup procedures for the SC-ES 9-Port or the SC-ES 18-Port
Ethernet Switch. Procedures for both units are the same except where noted. The 9-Port and the 18-
port units can be installed in a 16-slot SpectraComm shelf or a 10-slot MultiPak enclosure. The 9-
Port unit can also be installed in a 2-slot SpectraComm (SC2000) shelf or a single-slot
SpectraComm 1001 (SC1001) enclosure. The SC2000 shelf may be rack- or wall-mounted.
This chapter describes installing the SC-ES card, making power connections, performing pre-
operational checks, and making system connections. If this is your first installation of the SC-ES,
be sure to read the previous sections of this manual to understand the optimal functioning of the
SC-ES product as it applies to your network.
Shelf / Enclosure Installation Guidelines
• Locate the SpectraComm shelf in a ventilated area where the ambient temperature does not
exceed 122 degrees F (50 degrees C).
• Do not install the shelf directly above equipment such as power supplies, which generate large
amounts of heat.
SpectraComm Ethernet Switch Card Installation Guidelines
• The SC-ES card may be installed in any slot in a SpectraComm 5000 Shelf.
Note that each SC-18-Port occupies two slots.
• Perform the setups, connections, and pre-operation checks in their entirety, as described in this
chapter.