General DataCommc SpectraComm ES, Инструкции по установке и эксплуатации

Страница: 32 / 62

SC-ES Configuration Configuring SC-ES with Smart CLI
3-6 SpectraComm Ethernet Switch 076R204-000
Installation and Operation Manual Issue 2
7. Enable the desired port by typing the specific port number, or type
all
if all ports are to be
configured identically. Type:
configure ports enable
[port n] or [all]
8. Configure each enabled port for Auto-Negotiation by typing:
configure ports
[auto] [port n] or [all]
Note
If you configure the SC-ES for Auto-Negotiation, the port speed and the duplex mode will be determined at
each port by the unit. Therefore, you can skip steps 9 and 10 unless you want to adjust a specific port.
9. Configure the speed for each enabled port. For example, type 10mbps followed by the specific
port number, as follows:
configure ports
[10mbps] [port n] or [all]
10. Set each enabled port for half- or full-duplex mode. For example, type:
configure ports
[half] [port n] or [all]
11. Configure each enabled port for MDI/MDIX by typing:
configure ports mdix
[auto] [port n] or [all]
Note
Auto MDIX requires that Auto-Negotiation be enabled. Refer to Table 3-2 to understand what type of
negotiations will be in effect with the various SC-ES and ethernet device settings.
12. You have completed the configuration of the SC-ES. You can check your settings with the
following two techniques:
• Type
show config
to display the current configuration of the SC-ES.
• Test your network by pinging from your PC/workstation at the NOC to equipment at the
remote office, and vice-versa.
• You can also use the SC-ES ping utility to check connectivity
Table 3-2 Auto-Negotiation Guidelines
SC-ES Setting Ethernet Device Setting Negotiation Type
Auto-Negotiation + Auto-Negotiation = Speeds (10/100mbps)
Duplex modes (Full/Half)
FDX Flow Control
Manual Configuration + Manual Configuration = Not applicable:
Settings at both ends must match.
Auto-Negotiation + Manual Configuration = Speeds (10/100mbps)
Manual Configuration + Auto-Negotiation = Speeds (10/100mbps)