Gehl Z17 GEN:2, Руководство оператора

Страница: 88 / 208

13. Operating Instructions
2-48
1) Go down slopes at low speed, using the travel levers
and accelerator lever to control your speed.
When going down a slope, drive the machine at low en-
gine speed and position the implement as shown in the
figure at the right.
Also drive the machine with the track gauge widened by
operating the track gauge change control lever to keep
the machine more stable.
2) When going up a slope, drive the machine with the im-
plement positioned as shown in the figure at the right.
Also drive the machine with the track gauge widened by
operating the track gauge change control lever to keep
the machine more stable.
13-12. Precautions for going up and down a slope
• When traveling on a slope, place the implement
in the direction of travel and raise the bucket 8 to
12 in. (20 to 30 cm) above the ground.
• When driving over obstacles such as foot paths,
hold the implement close to the ground and drive
the machine slowly.
• Never turn on or traverse a slope.
Descend to flat ground to make a course change.
• If the machine is starting to slip or you feel that
the machine is unstable, place the bucket on the
ground and stop the machine at once.
• Recognize that the machine may roll over when
swinging the upper structure or operating the im-
plement on a slope.
Do not swing the upper structure toward the
downward side of the slope with a load in the
bucket.
If swinging is unavoidable, first lay earth on the
slope to maintain the machine as horizontal as
possible, then swing the upper structure.
• Do not travel on a slope of 20 degrees or more,
as the machine may upset.
Earth laid
on the
ground
020343-00E
000433-00X
020369-00E
7.87 to 11.8 in. (20 to 30 cm)
90 degrees to
110 degrees
90 degrees to
110 degrees
020354-00E
7.87 to 11.8 in.
(20 to 30 cm)
Courtesy of Machine.Market