Gehl 418T Wheel, Руководство оператора

Страница: 56 / 192

AP0902
3–19
Operation
Jump-starting the engine Safety instructions
•
Never jump-start the engine if the battery of the machine is frozen because of the risk of
explosion!
•
The machine must not touch the jump-starting machine when connected with jumper
cables because of the risk of sparking!
•
The external power source must deliver a rated voltage of 12 V; higher supply voltages
will damage the electrical system of the machine!
•
Use only jumper cables that are in good condition!
•
The jumper cable connected to the positive ( + ) terminal of the starting battery must
never contact metal machine parts because of the risk of short a circuit!
•
Route the jumper cables so they cannot catch on rotating components in the engine
compartment!
Proceed as follows:
• Drive the jump-starting machine close enough to the machine so that the jumper
cables can reach to connect the two batteries.
• Start the engine of the jump-starting machine.
• First connect one end of the red jumper cable ( + ) to the ( + ) terminal of the
discharged battery, then clip the other end to the ( + ) terminal of the starting battery.
• Connect one end of the black jumper cable (–) to the (–) terminal of the starting
battery.
• Clip the other end of the black jumper cable (–) onto a solid metal component
connected to the engine block or onto the engine block itself. Do not connect it to the
negative terminal of the discharged battery, because explosive gas from the battery
may ignite if sparks occur!
• Start the engine of the machine with the discharged battery
Once the engine has started:
☞
With the engine running, disconnect the jumper cables in exactly the reverse sequence
(first remove (–) terminal, then (
+ ) terminal) – this prevents sparking in the vicinity of
the battery!