Gehl 418T Wheel, Руководство оператора

Страница: 142 / 192

AP0902
5–29
Maintenance
5.10.3 Adjusting the wear pads
NOTE:
The (green) wear pads are located between the inner 163/C and outer boom sec-
tion 163/D.
The wear pads can be readjusted as they wear down – to a minimum thickness of
0.25 in (6 mm) only – by means of set screws 163/A and 163/B.
Do not overtighten the set screws, otherwise the telescopic unit is impaired and
does not work smoothly any longer.
Replace the wear pads upon reaching or falling below a minimum thickness of
0.25 in (6 mm)! In this case please contact your dealer.
☞
Adjust the wear pads as follows:
• Extend the telescopic unit by about 20 cm, so that the front wear pads can be easily
accessed
• Switch off the engine
• Prop the telescopic unit securely
• Loosen the locknuts at set screws 163/A and 163/B
• First align the inner boom section 163/C horizontally with the outer boom section 163/
D . To do this:
Screw in the set screws 163A (hexagon socket)
NOTE:
Screw in the set screws until the wear pads touch the pad tracks on the inner
boom section. Tighten the set screw by turning it a further 1/4 revolution.
• First align the inner boom section 163/C horizontally with the outer boom
section 163/D. To do this:
Screw in the set screws 163/B (hexagon socket)
• Tighten the lock nuts to secure all set screws 163A and B