Gehl 418T Wheel, Руководство оператора

Страница: 160 / 192

AP0902
6-5
Helpful information for using the service parts list
Validity
➜❙
Parts are valid only up to and including the serial number stated, e.g. up to and includ-
ing serial number 307 63 0238
➜❙
Parts are valid only up to and including the identification number stated for the
respective assembly, e.g. up to and including cab number 0237. This can also include
other symbols, e.g. axle, engine etc.
❙ ➜ Parts are valid only starting and including the serial number stated, e.g. starting and
including serial number 307 63 0239
❙ ➜
Parts are valid only starting and including the identification number stated for the
respective assembly, e.g. starting and including cab number 0237. This can also include
other symbols, e.g. axle, engine etc.
Symbol for axle
Symbol for cab
Symbol for engine
Instructions for assembly
Do not remove parts, parts cannot be repaired
Tighten parts with a torque spanner to the prescribed torque. Use standard torques if no
specific torque is stated – see section 7.16.1 General tightening torques on page 7-9 and
section 7 “Specific tightening torques” on page 7-9
Safety part!
For reasons of safety, parts may be dismantled or repaired by qualified mechanics only.
Otherwise parts must be replaced as a whole!
Check parts for wear before reassembly, e.g. bearings, rotary shaft lip seals etc.
Parts are not reuseable and must be replaced during repair work, e.g. sealing elements
Pay special attention to direction of installation when removing or fitting parts, e.g. rotary
shaft lip seals, bearings, bushings etc.
Use securing means and sealing compounds stated, e.g. Loctite 242
Measure length/thickness of new part, e.g. shims, edge guards, sealing strips etc.
Round up to the full metre for orders by the metre!
Measure thickness of new part, due to availability in various sizes.
State all dimensions in mm (millimetres).
Special symbols
Symbol for special version with float position
Symbol for hydraulic cylinder
Symbol for sealing kit
Symbol for tool kit
Symbol for documentation
Symbol
Description
6
7
8
0.15
0.2
0.5