Gehl 418T Wheel, Руководство оператора

Страница: 136 / 192

AP0902
5–23
Maintenance
Changing the oil
WARNING!
Draining hot hydraulic oil and removing the filter elements can be hazardous
because of the risk of burns.
☞
Wear protective gloves
☞
Use suitable tools, e.g. for unscrewing the oil drain plug
☞
Proceed as follows:
• Park the machine on level ground when the gearbox is at operating temperature
• Place a sufficiently large container under the transfer gearbox to collect the oil
• Clean and unscrew plug A on transfer gearbox B
• Unscrew plug C on transfer gearbox B
• Completely drain the old gearbox oil
• Tighten plug C with a new sealing ring to ensure an oil-tight seal
• Fill with oil until it runs out of the filler opening – see section 5.15 Engine fluids and
lubricants on page 5-39
If the gearbox oil level is sufficient:
• Tighten plug A with a new sealing ring to ensure an oil-tight seal
After conducting a test run:
• Check the oil level again after about 5 minutes, and top up if necessary
Fig. 157: Rear axle transfer gearbox
A
B
C