GE Multilin GEK-113328A, Инструкция по эксплуатации, Страница: 68 / 218

3-8 G650 Generator Protection & Control System GEK-113328A
3.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE 3 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES
3
3.1.5.2 ON LINE MODE
Figure 3–4: ON LINE MODE FILE MANAGEMENT
NO
Run EnerVista 650 Setup
Connect to the relay
(“ Communication>Computer>ON ”)
Modify and send to the
relay protection Settings
and relay configuration
Is it necessary to
program
additional logic?
Launch the Logic Configuration tool in EnerVista
650 Setup (“ Setpoint>Logic Configuration ”)
Create new or modify the existing logic
(“ File>Open Project ”)
Compile (“ Run>Compile ”)
and save logic file (*.pep) and drawing design
(*.aut) in Logic Configuration tool (“
File>Save
Project ”)
Send logic to relay (“ Run>Send Equations to
Relay ”) and Exit PLC Graphic Editor
Is the relay
completely
configured?
Save all settings & configuration (“ File>Get info from relay ”)
Store in the relay the Logic configuration files (*.pep, *.aut, *.lib) as well as the
*.650 for further logic changes. (“ Communication>Upload info files to relay ”)
NO
YES
YES