GE MobileView 4, Руководство по установке

Страница: 23 / 106

Chapter 2
Camera installation
13
Flush-mount
There are two types of flush-mount cameras—square and angled. Flush-mount camera
assemblies are mounted flush with the side panels of the vehicle.
Note: The square bezel that holds the glass camera cover has countersunk holes in the backside that
cover the two housing screws. The housing and bezel screws are separate to allow access to the camera
for focusing and adjusting while the housing is held firmly in place.
1. Leave at least 6 in. (152 mm) of clearance behind the mounting location.
2. Cut a 3.25 by 3.25 in. (83 by 83 mm) hole in the appropriate location on the
mounting surface.
3. Using the housing as a template, mark the location of the mounting holes.
4. Using a 3/16 in. (5 mm) drill bit, drill the mounting holes.
5. Connect the video and power cables to the camera assembly.
6. Mount the camera assembly to the vehicle surface using two fasteners screwed into
panel nuts ( Figure 7 ).
Figure 7. Housing installation
7. See Field of view on page 14 to align the camera’s field of view to the appropriate angle.
8. Attach the cover plate to the housing ( Figure 8 on page 14). If you are installing a
square housing, you must drill two additional mounting holes for the cover plate.
Angled flush-mount housing
Square flush-mount housing