GE MobileView 4, Руководство по установке

Страница: 18 / 106

MobileView 4
Installation Manual
8
System layout
Camera layout and fields of view vary based on several factors. Vehicle seating
arrangements, partition walls, door location, and customer guidelines are but a few of these
factors. It is the responsibility of the installer to ensure these factors are adequately
considered
before installation begins.
Figure 2 shows a typical, eight-camera layout. While most areas of the vehicle are covered
when cameras are located in this manner, this illustration is provided as a guide and not a
rule for actual camera placement. In all new installations, you should obtain customer
acceptance of camera location and fields of view as part of installation planning.
Figure 2. Typical eight-camera setup with fields of view shown
6
7
8
1
2 3
4
5
1
Front door camera. Front of
the bus over the driver’s
head, looking at the front
passenger entry.
2
Forward-facing camera.
Front of the bus, looking in
front of the bus.
3
Front-to-rear camera. Front
of the bus, looking down the
center aisle to the back.
4
Rear exit camera. Across
from the back door, looking
at the back doorway.
5
Rear-to-front camera. Back
of the bus, looking up the
aisle to the front of the bus.
6
SideEye side camera.
Exterior of the bus by the
front door, looking toward
the back of the bus.
7
Center-to-rear camera.
Between the front and back
door, looking down the
center aisle to the back of
the bus.
8
SideEye rear camera. Back
of the bus, looking behind
the bus.
Note: Cameras 6 and 8 in Figure 2 are MobileView SideEye cameras; camera 2 is a MobileView forward-
facing camera. For installation of these cameras, see their respective manuals, shown in References and
related documents on page 5.