33
Aadva Lab Scanner 2
Manual
FLEXIBLE OBJECT HOLDER
Jaw models (upper or lower jaw) can be securely fastened on the flexible object holder with the big plate. To fasten
them, you require adhesive glue pads.
Two packs of adhesive pads are included in the scope of delivery. You can purchase replacements from office suppliers
if required.
•
Cover the topside of the plate with adhesive pads. You should use at least three pads for complete jaw models.
•
Place the jaw model (upper or lower jaw) with the bottom side on the adhesive pads.
The anterior teeth point in direction of the single magnetic point (
1
).
1
•
Press the jaw model firmly.
The jaw model is placed correctly when it does not extend beyond the magnetic points.
•
Tilt the object holder carefully to the right and left.
The jaw model is placed correctly when it does not slip.
•
Should the jaw model slip, use additional adhesive pads.
INSERTING THE OBJECT HOLDERS
The described procedure is the same for both object holders.
OBSERVE THE SAFETY INSTRUCTIONS!
•
Hold the object holder from the side.
•
Place the object holder with the front side or the knurled screw facing forwards inside the scanner.
The protrusions (“Ovals”) on the underside of the object holder engage with the recesses of the Multisplit base plate.
The object holder will adhere to the magnet of the Multisplit base plate.
•
Check whether the object holder can be shifted easily. If this is the case, correct the fit until the object holder
fits securely.