44
12. Positioning objects (universal mode)
Scannable objects are very individual physical bodies. Thus, only general advice on correct positioning can be
provided here. In principle, GC recommends using the flexible object holder for the Universal Mode.
FLEXIBLE OBJECT HOLDER
1. Front
2. Rear
3. Top
4. Magnetic points
5. Adesso Split® plastic plate with adhesive disk
1
2
3
4
5
With this object holder, solid, opaque objects such as tools,
jewelry or toys with a maximum size of 85,2 × 58,1 × 82 mm (XYZ)
and a maximum weight of 0.938 kg can be scanned.
85,2 × 58,1 × 82 mm (XYZ)
0.938 kg
PROPERTIES OF SCANNABLE OBJECTS
Glossy surfaces (such as metal) or very dark surfaces cannot be scanned. Reflections and lack of contrast to the
scanner’s interior make an accurate measurement impossible. Therefore, such objects should be matted with 3D scan
spray.
Dimensional stability
Only objects that do not change their shape during scanning can be scanned. Make sure that moving parts are
adequately immobilized.
Top and bottom
To fully digitize a three-dimensional object, it usually needs to be scanned from two sides. The second scan captures
the bearing surface that was hidden during the first scan. In the simplest case, turn the object on the object holder.
Depending on the shape of the object, it may be useful to choose a different fastening for the second side.
12.1. Fastening objects on the flexible object holder
OBSERVE THE SAFETY INSTRUCTIONS!
Objects can be fastened securely on the flexible object holder with the big plate.
Try out the best way to fasten an object.
Test the stability of the fastening outside the scanner using sideways and rotational movements to determine which
object holder best fits an object. Create sample scans and compare the results.
So you can, for example, place jewelry instead of single-tooth models into the Multi die adapter or clamp them into the
Triple Tray® impression holder. The object holder with the knurled screw can achieve good results with solid bodies
having a wide, smooth underside. Please note that Multi die adapters and Triple Tray® impression holders can only
support smaller, lighter weight items (<85,2 x 58,1 x 82 mm (XYZ), 0.938 kg).
