Operations
Page 5 - 3
Orca III/ Orca III T Operation and Maintenance Manual
© GBC Films Group February 2001
( 5 ) Temperature Control Unit ( Top ): This unit is
used to set the desired heating temperature of the top
main roller. The display can be programmed to show
o
F or
o
C. Maximum temperature is 290
o
F ( 143
o
C ).
C A L 3 2 0 0
3 2
C A L 3 2 0 0
3 2
( 6 ) Temperature Control Unit ( Bottom ): This
unit is used to set the desired heating temperature of
the bottom main roller. The display can be programmed
to show
o
F or
o
C. Maximum temperature is 290
o
F
( 143
o
C ).
C A L 3 2 0 0
3 2
C A L 3 2 0 0
3 2
( 7 ) Top Heater on / off Switch: Turns the
temperature controller unit for the upper main roller
to on ( I ) or off ( O ).
H E A T
T O P
BO TTO M
T op and bottom tem perature con trol units
on/ off sw itches m ust be in the O N ( I )
position to heat either roller.
IN F O R M A T IO N
( 8 ) Bottom Heater on / off Switch: Turns the
temperature controller unit for the lower main roller
to on ( I ) or off ( O ).
H E A T
TO P
B O T T O M
T op and bottom tem perature con trol units
on/ off sw itches m ust be in the O N ( I )
position to heat either roller.
IN F O R M A T IO N
( 9 ) Main Roller Pressure Adjustment: Adjusts the
air pressure supplied to the main roller air cylinders.
Pull out on the knob to turn and push in on the knob
to lock down.
PR ESSU R E
R O LL
A D J
10
20
30
40
50
60
70
80
90
100
0
P.S.I.
W hen decreasing pressu re, allow the
pressure guage to drop b elow the desired
value, then increase pressure to th e set
pressure desired. T his allow s for a m ore
accurate pressure readin g.
IN F O R M A T IO N
