60
Adjust the headlamps in the following sequence:
– check air pressure in tires. Bring it, if necessary, to the required level;
– place the unladen vehicle on a level ground at 5 m distance from the
screen (Fig. 8.5);
– bring «0» on the handwheel into coincidence with the mark on the hous
ing of the headlamp aiming device;
– turn on the dipper beam;
– adjust the light beams by knobs
2
(Fig. 8.4) and through opening
4
for
each headlamp in turn.
Caution!
When fitting a halogen bulb in the headlamp, do not touch the
bulb glass with the fingers to avoid luminous flux reduction or bulb rapid de
struction during its operation.
The horizontal section of light and shade border of adjusted headlamps must
coincide with line X–X (Fig. 8.5A, 8.5B), the inclined section of the light and
shade border must correspond to Fig. 8.5A (with “AL” marking on the lenses)
and Fig. 8.5B (with “ОСВАР” marking on the lenses), and the points of hori
zontal and inclined sections of the line and shade border intersection must co
incide with G–G and D–D lines.
8.8. FUSES
Vehicles with ZMZ4061, 4063, 40522 Engines
Under the hood on the right there is a fuse box БПР2 where 40A fuse
protects illumination circuit of the vehicle and 60A fuse protects general posi
tive circuit of the vehicle except for illumination and starter circuits.
On the left under the instrument panel two fuse boxes БПР13 are installed
on the bracket.
Fig. 8.5.
Screen Layout for Headlamps Adjustment:
A – headlamps with “AL“ marking on the lenses; B – headlamps with “ОСВАР” marking on the
lenses; h – height of vehicle headlamp dipper beam center; Y – Y – vehicle axis.
Dimensions in brackets are for 4WD vehicles.
