Gateway 9515, Руководство пользователя

Страница: 146 / 194

141 www.gateway.com
■
Turn off your server, then remove all hard drives and push them in again to make
sure that the drives are seated correctly. For instructions, see
“Installing a hard drive”
on page 64 .
You are having problems with a SATA drive
■ For normal SATA drives (not SATA RAID), check the BIOS setup utility to see if the
BIOS has recognized the drive.
■ Make sure that the power cable and SATA cables are attached securely to the drive cage.
■ If the drive is not detected, try a different SATA port.
■ Try swapping SATA cables between drives to determine if the cable is defective.
■ Try listening to the drive to determine if the drive is spinning up. If not, the drive
may be defective.
The master boot record is corrupted
■ In a Windows network operating system, repair the master boot record using FDISK.
To repair the master boot record:
■
At a DOS command prompt, type fdisk/mbr , then press E
NTER
.
Internet
See also Modem .
You cannot connect to the Internet
■ Make sure that your account with your Internet Service Provider (ISP) is set up
correctly. Contact your ISP technical support for help.
■ Make sure that you do not have a problem with your modem. For more information,
see
“Modem (telephone dial-up)” on page 142 .
Keyboard
Liquid has been spilled into the keyboard
■ If you spilled liquid in the keyboard, turn off your server and unplug the keyboard.
Clean the keyboard and turn it upside down to drain it. Let the keyboard dry before
using it again. If the keyboard does not work after it dries, you may need to replace it.
This type of damage is not covered by your server’s warranty.