Gateway 9515, Руководство пользователя

Страница: 69 / 194

64
www.gateway.com
Installing a hard drive
Use this procedure to add or replace a hard drive in a hot-swap bay. Your server supports
as many as five 1-inch high 3.5-inch hot-swap SATA or SCSI hard drives (six with optional
sixth drive board). You can purchase additional drives through your Gateway Sales or
Customer Care representative.
To install a hot-swap hard drive:
1
Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
2
Press the green release button on the hot-swap tray lever, then swing the lever open
all the way.
3
Pull the drive carrier straight out of the server.
Important Gateway tests and verifies the operation and compatibility of the
drives it sells. Especially in a hot-swap or mission-critical
environment, additional or replacement drives must conform to
Gateway standards.
Caution Before you remove a failed drive, use the appropriate software and
utilities installed on the server to stop all activity on the failed drive.
Instructions for using the software are provided by the software
manufacturer. Failure to do so may destroy the data on the drive.