Gateway 9515, Руководство пользователя

Страница: 113 / 194

108
www.gateway.com
Replacing the system board
To replace the system board:
1
Follow the instructions in “Preventing static electricity discharge” on page 43 . Make
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in “Opening the server case” on page 44 .
3
Remove the processor air duct by following the instructions in “Removing the
processor air duct” on page 47 .
4
Remove the PCI riser assembly by following the instructions in “Removing and
installing the PCI riser assembly” on page 79 .
5
Remove the memory modules by following the instructions in “Installing memory”
on page 76 .
6
Remove the fan module by following the instructions in “Replacing the fan module”
on page 85 .
7
Remove the heat sinks and processors by following the instructions in “Installing a
processor” on page 88 .
8
Disconnect all cables from the system board, noting their locations and orientation.
(You will reconnect the cables after you install the new board.)