Gateway 9515, Руководство пользователя

Страница: 86 / 194

81 www.gateway.com
To remove and install a PCI riser connector:
1
Follow the instructions in “Preventing static electricity discharge” on page 43 . Make
sure you turn off the server, then unplug the power cord and all other cables connected
to the server.
2
Follow the instructions in “Opening the server case” on page 44 .
3
Follow the instructions in “Removing the processor air duct” on page 47 .
4
Remove the PCI riser assembly from the server by following the instructions in
“Removing and installing the PCI riser assembly” on page 79 .
5
Remove any installed PCI expansion cards by following the instructions in “Removing
a PCI expansion card” on page 82 .
6
Push in on the blue release lever at the end of the PCI riser connector.
7
While holding the lever in, push firmly on the front edge of the PCI riser connector,
then slide it to the back to disengage the connector from the riser retention pins.
8
Place the PCI riser connector in a static-free bag to store it for future use.