Gates OPTICAM 4S, Руководство по эксплуатации, Страница: 20 / 26

20
GATES.COM
OPTICAM 4S / OPTICAM 4S DP
OPERATING MANUAL
The authorised person can enter in the “preset
counter” fi eld a number of work cycles, after
the achievement of which the next maintenance
measure must be carried out. After reaching the
work cycle number, the error message “maintenance
due!” appears.
After the protective measure has taken place, the
authorised person can reset the actual maintenance
counter number by pressing the “reset” button
and enter a new work cycle number until the next
maintenance measure.
The counter “machine cycles” counts all commenced
work cycles and cannot be reset.
7.3.4 Tool counter
After clicking this button the following appears:
Tool counter 1 to 6
Here all work cycles are counted with the respective
tools (according to the above stated tool list).
The authorised person can reset this number of
work cycles.
By pressing the
>>>
button, the next page of the
tool counter is displayed.
7.3.5 Message buffer
All error messages that have been displayed and
deleted in the message window are listed here. The
authorised person can also delete this message buff
er if necessary.
7.4 ASSEMBLY IN CHRONOLOGICAL ORDER
7.4.1 Setup of tools
After switching on the machine main menu appears
acc. chapter 7.2.2. For each tube size there is a
separate pair of tools. Each pair consists of one
assembly socket and one counter plate.
Assembly socket
Counter plate with coding on
right side