Gates OPTICAM 4S, Руководство по эксплуатации

Страница: 11 / 26

11
GATES.COM
OPTICAM 4S / OPTICAM 4S DP
OPERATING MANUAL
4.5.3 Improper use
The cutting ring assembly device Opticam 4S may
not be used for pressing in other round materials
or other materials and work pieces that are not
designated for this machine.
INFO
Unauthorised changes to the machine shall lead to
the EEC declaration of conformity becoming void as
well as to the loss of all warranty, guarantee and
damage claims!
4.6 TECHNICAL SPECIFICATIONS
TUBE OUTSIDE
DIAMETER X
WALL THICKNESS
OPTICAM
4S
OPTICAM
4S DP
Height 635 mm 635 mm
Widht 660 mm 670 mm
Depth 310 mm 310 mm
Weight 92 kg 99 kg
Electrical connection 400 V,
16 A, 5-pole
400 V,
16A, 5-pole
Noise level of the
machine in operation < 70 dB(A)
< 70 dB(A)
Hydraulic oil HLP 32 HLP 32
Volume of the
hydraulic system
5 litres 5 litres
Max. pressure in the
hydraulic unit
400 bar 400 bar
4.7 DANGER AREA
DANGER!
Only one person may be in the work area of the
cutting ring assembly device. Other persons must be
kept away from the work area.
The danger area exists in the lifting range of the
horizontal running piston rod at the work area of the
cutting ring assembly device:
4.8 ELECTRICITY
The cutting ring assembly device may only be
operated with a three-phase alternating current 400
V, 16 A, 5-pole.
If there are any disturbances in the electrical power
supply the device must be switched off immediately!
After the loss of the electrical connection the cutting
ring assembly device Opticam 4S stops functioning
and the piston rod with the inserted assembly tool
remains in its current position.
The piston rod is set in motion by pressing the green
button next to the control panel and stopped by
releasing the button.
With an installed proximity switch, the pressing
procedure is initiated by pressing the work piece
against the switch. Taking the work piece off the
switch halts the forward movement.
The control system registers an assembly abort
in both cases of shutdown, after pressing the F3
button on the control panel the press tool drives
back into the basic position and re-enables the work
piece insert.
INFO
The electrical main switch next to the control panel
carries out the function of the
emergency stop switch.
4.9 DISRUPTIVE INFLUENCES
All disruptive infl uences must be avoided in the
surroundings of the cutting ring assembly devices.
DANGER!
Welding, burning and grinding works may not be
carried out in the work area of the cutting ring
assembly device.
The device may not come into contact with water
because this may result in hid den damage to the
device, which will later lead to incalculable risks for
the physical soundness of the operating personnel.