GAS GAS WILD HP 450, Руководство по обслуживанию

Страница: 51 / 63

Where you must be most careful: Avoid applying high-pressure
water near:
Brake caliper and brake pump piston below the fuel tank (if water
enters the electric coil or in the spark plug boot, the quad will not
start and the wet parts must be dried out), Front and rear hubs;
suspension system; swing arm bearings.
- Wash all surfaces with hot water and neutral soap.
- Rinse the machine with clean water and dry all the surfaces with
a soft and absorbing cloth.
- Clean the seat with a vinyl-lining cleaner so as to keep it soft and
shiny.
- You can apply automotive wax to all chromed and painted surfaces.
Avoid using wax combined with cleaning products. Most of these
products contain abrasive elements that might make the paint matt
and destroy the paint finish. When you have finished, start the engine
and leave it idling for some minutes.
WARNING
Wet brakes may lose efficiency, and lead to risk of accident. Test
the brakes after washing the quad and apply them several times at
low speed, so that friction dries them out.
After washing the quad
- Remove the plastic bags and clean the air filter inlet.
- Lubricate the points listed in the lubrication section.
- Start the engine and warm it up for 5 minutes.
LUBRICATION
Lubricate these parts with engine oil or grease; do it periodically or
after riding in rainy conditions, and specially after using high-pressure
water to wash the vehicle. Before lubricating each part, clean the
oxidised parts with anti-oxidiser and remove any trace of grease, oil
or dirt.
(1). Clutch
lever.
(2). Front
brake lever.
3). Rear brake
lever.
(4). Rear brake
bearing.
(5). Gear
lever.
(1) (2)
(3)
(4)
(5)
WILD HP -
116
-