52
Appendix B
Wiring and Interfacing
The Navigator can be connected to a PC, beacon receiver, marine autopilot or other compatible
device using the supplied PC Interface Cable with RS-232 Serial Port Connector (P/N 010-10141-00).
The Navigator can be connected to a vehicle’s electrical system and a PC, beacon receiver, marine
autopilot, or other compatible device using the optional PC Interface Cable with Cigarette Lighter
Adapter (P/N 010-10165-00).
The Navigator may be hard-wired to the vehicle’s electrical system (10-32 VDC) and a PC, beacon
receiver, marine autopilot or other compatible device using the Power/Data Cable with bare wire leads
(P/N 010-10082-00).
WARNING: the terms of the GARMIN Warranty require that the Power/Data Cable with
bare wire leads be installed by experienced installers at a qualifi ed installation facility
(i.e., your BMW dealership). The user should not attempt installation without proper
knowledge of motorcycle/automotive electrical systems and skill in the use of special tools
or hardware required for installation.
Consult the wiring diagrams at the side and bottom of the page for proper connections. (The
male connector on the back of the Navigator and wiring leads are illustrated to the right, wiring lead
color coding is illustrated below.)
I
(-) Ground
Data Out
Data In
(+) Power
Power and Data Connections from the back of the unit.
To attach the optional portable antenna: rotate to the
position shown in the picture above and gently push
onto the unit. The antenna port accepts a standard BNC
connector.
RF Owners Manual Rev A.indd
08/20/01, 11:24 AM
52