42
AFTER SALES SUPPORT
1300 855 831
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
AUS
Maintenance
Immediately replace damaged or blunt cutting tools, even in the event of minor
damage.
Oiling the chain wheel / Pole saw (Fig. 47)
Oil the gear unit every 10 to 20 operating hours.
1
Position the grease gun at the lubricating nipples (A13).
2
Insert some grease.
Oil the cutting tools and the angle adjustment with environmentally friendly lubricant.
Adjusting the idle speed (Fig. 50)
If the cutting device runs idle, correct the idle speed.
1. Allow the engine to warm for 3-5 minutes (No high speeds!).
2. Turn the adjusting screw (A17):
clockwise
- idle speed increases (+)
anti-clockwise
- Idle speed decreases (-)
The idle speed is 3000 ± 200 min
-1
Contact the manufacturer if the cutter continues to run at idle.
Do not continue to operate the unit!
The user is responsible for all damages caused by non-compliance with instruc-
tions in this user manual. This also applies to non-authorized modifications of the
5 in 1 Petrol Tool, use of non-authorized spare parts, accessories, working tools,
unrelated and not intended use, secondary damages due to use of faulty compo-
nents.
Wear Parts
Even when used in the intended way, some components are subject to normal wear.
They have to be replaced depending on the kind of duration of usage. These parts in-
clude, among others, the cutting tool and the retaining disk.
m
Warning! Use only original manufacturer‘s replacement parts, accessories and at-
tachments. Failure to do so can cause poor performance, possible injury and may void
your warranty
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and
petrol!
Ordering replacement parts
Please quote the following data when ordering replacement parts:
• Type of machine
