AFTER SALES SUPPORT
31
1300 855 831
AUS Hotline Costs: Local rate for landline calls*
*Charges may vary dependent upon network operator or mobile network provider.
MODEL: Garden 5 in 1 Petrol Tool PRODUCT CODE: 58903 03/2019
AUS
Attachment and operation/Working instructions
6. To start the cutting tools, operate the Throttle lever "Lock" (3) with the palm of your
hand, and the Throttle lever (6) with your fingers. The further you push the Throttle
lever (6), the higher the motor speed. When releasing the Throttle lever (6), the motor
becomes idle and the cutting tools stop. (Fig.23.) The cutting tools should not continue
turning and should not move when the motor is idle.
7. If there are problems, immediately turn the ON / OFF switch (2) to "0" so the motor
stops.
m
Caution! The cutting tools may continue turning for a few seconds.
8. If any problem occurs, pull the safety latch (M), then release the Brush cutter immedi-
ately. (Fig. 17)
9. If the motor is warm, you can leave the choke lever (Z) in the "warm start and work"
position
.
Note: If the engine does not start up even after several attempts, read the section "Trou-
bleshooting".
Note: Always pull the Recoil starter (4) out in a straight line. If it is pulled out at an angle,
then friction will occur on the eyelet. As a result of this friction, the cable will become
frayed and will wear away faster. Always hold the Recoil starter handle when the cable
retracts.
Never allow the cable to snap back when it has been pulled out.
Note: Do not start the motor in tall grass.
m
Attention: When the engine has been switched off, the cutting unit continues run-
ning for several seconds therefore do not touch the cutting unit until it has come to a
standstill!
IX. Working instructions
Working with Brush cutter / Grass trimmer
• When you work with the Brush cutter for the first time, familiarize yourself with the
operation and control of the 5 in 1 Petrol Tool without running engine.
• The design of the Brush cutter allows for operation only at the right side of the user's
body.
• Keep the Brush cutter firmly with both hands on the handles.
• Always make sure that the cutting tool continues to rotate briefly after the throttle has
been released.
• Be aware that the cutting tool does not rotate when idling and throttle is not actuated.
• Always work with high speed so you have the best cutting results.
• If the cutter hits a stone or a tree when working, turn off the engine and remove the
spark plug then examine the Brush cutter for damage.
• Caution: Always be extra careful when working in difficult terrain and slopes. Cut tall
grass gradually so as not to overload the unit.
